Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

bri configuration

please i have customer need to implemnt ccme and make voice call through bri VIC2-2BRI-NT/TE so please i need any example of configuration or any websites that talk about how to configure the bri port and the dial-peer

4 REPLIES
Hall of Fame Super Gold

Re: bri configuration

Do you have multiple BRI or a single one ?

If multiple BRI, put them under trunk-group and reference it as destination for DP.

The needed configuration would then be:

interface BRI0/2/0

no ip address

no logging event link-status

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn tei-negotiation preserve

trunk-group my-trunk

voice-port 0/2/0

no vad

compand-type a-law

Hope this helps, please rate post if it does!

New Member

Re: bri configuration

please can u send for me a complete configuration or any refrence explain the configuration

Hall of Fame Super Gold

Re: bri configuration

There are too many variables involved for sending complete configurations and hope that it will work.

If you have never configured CME, do the telephony-setup wizard, if you have problems explain here and someone will try to help.

New Member

Re: bri configuration

i need also to know how can i determine if i need to configure the port in the network mode or in the terminal device mode

182
Views
0
Helpful
4
Replies
CreatePlease login to create content