Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

BRI France Telecom

Hello,

I have 2 CCME in Frans.

With 4 BRI.

I tried to set-up these BRI.

The BRI receive and can place call, but disconnect/reconnect all the time.

On a sh isdn status, most of the time, when there isn't any call, the layer 1 is deactived.

I have other CCME in other countries, and no problem, the layer 1/2 is always up...

I tried with statis tei, dynamic tei, ...

The best result is with tei negotitation first-call, with that, I can place call if the layer 1 is down, that automatically activate it.

But at the end of the call, the BRI is disconnected.

It's on 2 different site, and FranceTelecom has tested the lines, all is ok.

The only think I know from FT is that it's ISDN of type Numeris+.

Is it possible to keep these BRI up ?

Thx

7 REPLIES
Hall of Fame Super Gold

Re: BRI France Telecom

Hi, everywhere in Europe BRI layer 1 is brought down by the CO after a timeout. You cannot change this behavoir.

In consequence of that, the best setting is "isdn tei negotiation preserve". You also need to configure

network-clock-participate WIC x

network-clock-select 1 BRI x/y

repeat this for all ports in decreasing priority.

If still problems, post you configuration and the exact IOS used.

Hope this helps, please rate post if it does!

New Member

Re: BRI France Telecom

I tried like this.

And also tried with negotiation at first call.

All is good except when I use callforward feature.

With this, I receive the call, CCME try to forward the call (to an external num), and that fail.

opn Q931 debug, I see that the call is rejected.

If I reswitch to static tei, all is good.

Hall of Fame Super Gold

Re: BRI France Telecom

When there are multiple BRIs in huntgroup, it's always static tei, sometime telco calls this "PBX".

New Member

Re: BRI France Telecom

Hi,

Did you find the solution?

I have a trunkgroup with 4BRI and only inbound calls work well.

could you send me your configuration? It will be a great help for us ?

thanking you in advance,

Hall of Fame Super Gold

Re: BRI France Telecom

He was using a standard configuration:

I tried like this.

And also tried with negotiation at first call.

All is good except when I use callforward feature.

Please mention the IOS you are using.

lus
New Member

Re: BRI France Telecom

Hi, do you have a dialplan from france? Thanks

Hall of Fame Super Gold

Re: BRI France Telecom

Already replied in another thread, please open new thread about new problem (beside, I think you had asked this already).

461
Views
0
Helpful
7
Replies
CreatePlease to create content