CME 4.1 system with 2 x 2 port bri cards installed.
currently we have a single hunt group which all incoming calls go into.
voice ports are using :
connection plar 1050
(which is hunt group pilot) to direct all incoming calls.
Hunt group works as expected when called internally, but external incoming calls seem to ring 2 phones simultanously instead of just 1! Then when it it reaches timeout (because of no answer) the next 2 numbers in the hunt group list start to ring.
It appears as if the system thinks there are two calls incoming instead of just 1.
post your configuration just to make sure. you don't need to use connection plar on bri lines. You should receive incoming called number information automatically... for BRI is usually the 7 digit directory number. for PRI is usually the 4 digit extension code.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...