06-17-2008 01:17 AM - edited 03-15-2019 11:19 AM
Hi,
I have an issue where the BRI ports are not always been released after making a call they get permanantley stuck in the state. Details below:
sh voice call summ
PORT CODEC VAD VTSP STATE VPM STATE
============== ======== === ==================== ======================
0/1/0.1 - - -
0/1/0.2 - - -
0/1/1.1 - - -
0/1/1.2 - - -
0/3/0.1 - - -
0/3/0.2 None - S_SETUP_FAIL S_TSP_WAIT_RELEASE
0/3/1.1 - - -
0/3/1.2 None - S_SETUP_FAIL S_TSP_WAIT_RELEASE
IOS version is 12.4(1)exp.
Config for the BRI is :
nterface BRI0/2/0
description QSIG Trunk in TE mode
no ip address
isdn switch-type basic-qsig
isdn overlap-receiving T302 3000
isdn tei-negotiation remove
isdn point-to-point-setup
isdn incoming-voice voice
isdn global-disconnect
isdn send-alerting
isdn sending-complete
isdn static-tei 0
isdn timeout-signaling
isdn skipsend-idverify
I think this is looking like a software bug but was wondering if anyone has ever seen this.
Any help appreciated.
Cheers
Kev
04-17-2010 07:23 AM
Try 12.4(22)YB5.
04-19-2010 02:37 AM
Hi,
Its been a long time since i had this problem but if i remember rightly the IOS and the PBX software had to be upgraded to resolve the issue in my case.
Thanks
Kev
04-25-2010 08:47 AM
Hi,
Before I installed this version I noticed that I was no longer getting the same error message that you responed to. The issue had been escalated to the Service Provider so I'm wondering if they made any changes. Instead the gateway was sending disconnect with 'Network out of order' message.
This turned out to be a simple configuration error. (I had missed the h323 interface statements).
Thanks to all of you who tried to help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: