Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

BRI on C2811 with Deutsche Telekom

Hello all,

iam trying to configure my BRI wic with ISDN line from Deutsche Telekom but without success with this message:

"**ERROR**: Ux_BadMsg: Invalid Message for call state 11, call id 0x8007, call ref 0x5, event 0x62"

. I can calling everywhere, i can receive calls but both type of calls end after i pick up the phone.

Here is BRI cfg:

!

interface BRI0/0/0

no ip address

isdn switch-type basic-net3

isdn timer T310 10000

isdn overlap-receiving

isdn twait-disable

isdn point-to-point-setup

isdn layer1-emulate network

isdn autodetect

isdn incoming-voice voice

isdn map address type plan unknown type unknown

isdn sending-complete

isdn outgoing-voice info-transfer-capability 3.1kHz-audio

isdn static-tei 0

isdn timeout-signaling

isdn skipsend-idverify

end

output from "debug isdn q931" is in attachment debug.txt

Can you help me please with it ?

Thank a lot.

Best,

Lukas

1 REPLY
New Member

Re: BRI on C2811 with Deutsche Telekom

i solved it - removed "isdn autodetect"

550
Views
0
Helpful
1
Replies
CreatePlease to create content