Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BRI - Outgoing call setup error

Hi,

i am experiencing the following problem when establishing calls over BRI ports. There are 6 BRI ports configured as a trunk group and are configured like this:

BRI configuration:

isdn switch-type basic-net3

isdn overlap-receiving

isdn not-end-to-end 64

isdn incoming-voice voice

isdn outgoing-voice info-transfer-capability 3.1kHz-audio

isdn outgoing display-ie

The incoming calls are working fine, but outgoing calls fail. The call setup goes like this:

1. TX->SETUP

An then instead of RX->Call_Proc i get:

2. RELEASE_COMP pd = 8 callref = 0x8D Cause i = 0x82E404 - Invalid information element contents

Any ideas how could this be solved?

Regards,

Marko

7 REPLIES

Re: BRI - Outgoing call setup error

do u have the network-clock-participate wic

configured?

New Member

Re: BRI - Outgoing call setup error

Yes, for all three slots.

New Member

Re: BRI - Outgoing call setup error

The soultion was to force TEI=0 towards provider.

New Member

Re: BRI - Outgoing call setup error

Hi Marko,

Wondering how did this issue was resolved? I am having exact issue.

Thanks

Shine

Hall of Fame Super Gold

Re: BRI - Outgoing call setup error

Have you read above ?

The soultion was to force TEI=0 towards provider.

New Member

Re: BRI - Outgoing call setup error

Forcing TEI value to zero makes the BRI layer 2 comes up and multiple frames establishes, and eventually, the incoming calls worked. Dependning on your ISDN switch type, the outgoing call may or may not work with this setting. If you are connected to a-law compatible switches at the telco, susch as Basic-net3, then you must chnage the compand-type value on the voice-port to a-law. This was the fix in my case.

Thanks for the response.

Hall of Fame Super Gold

Re: BRI - Outgoing call setup error

You're welcome, please remember to rate useful posts with the scrollbox below.

178
Views
0
Helpful
7
Replies
CreatePlease login to create content