We have a VIC2 - BRI-NT/TE card installed and configured with CME. Incoming and outgoing calls are working fine. Also, incoming calls with DID are working.
Now the customer wishes to have DID for outgoing calls, meaning that extension 101 when reaches the PSTN network obtains the primary line as caller ID of the ISDN supplier and when extension 102 reaches the PSTN network obtains the seconday line as caller ID.
I would appreciate helping me in accomplishing the above.
Below is the ISDN router's configuration so far:
interface BRI0/0/0 no ip address isdn switch-type basic-net3 isdn tei-negotiation first-call isdn point-to-point-setup isdn incoming-voice voice
voice-port 0/0/0 compand-type a-law
dial-peer voice 2121 pots destination-pattern XXXXX...... port 0/0/0
dial-peer voice 1121 pots incoming called-number . direct-inward-dial port 0/0/0
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...