Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BRI slow to dial

Hi All

CME 4 with Bri connection takes about 20 seconds to establish an outgoing call via BRI.

Where do I start to diagnose problem?

Port setup as follows:

interface BRI0/2/0

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn static-tei 0

isdn skipsend-idverify

normal dial-peer with 9T setup for outgoing calls.

Thanks in advance

3 REPLIES
Hall of Fame Super Gold

Re: BRI slow to dial

How you interdigit timeout is set ?

New Member

Re: BRI slow to dial

We're pressing # to complete the call.

Hall of Fame Super Gold

Re: BRI slow to dial

Please add "isdn sending-complete" under interface. If no change, please send the usual debug isdn q931, preceded by a "show clock" at the time you press #.

Does it happens with all the numbers ?

115
Views
0
Helpful
3
Replies