cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
407
Views
0
Helpful
1
Replies

Bulk FXO device?

omair.siddiqui
Level 1
Level 1

My customer is intended to run FXO instead of PRI for billing purpose. They need 48 Port FXO termination. I fear  that VG-248 is intended for FXS termination. Is there any device  available to serve this purpose?

1 Reply 1

William Bell
VIP Alumni
VIP Alumni

By billing I assume you mean cost?  You are correct the VG248 will not help you.  You would need a high density FXO or DID solution (depending on what you need and how you configure trunks from carrier).  Take a look here:

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/exvoimod.html

http://www.cisco.com/en/US/products/hw/modules/ps2617/products_configuration_example09186a0080513001.shtml

Analog DID requires you to order that particular service from your carrier.  I haven't used these interfaces in production (well, not as analog DID anyway).  So you may want to research that a little.

HTH.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: