I have a new bundled SRST box and I`ve configured ccm-manager fallback etc and the mgcp. Sh ccm-manager shows it is registered and I`ve configured some FXS ports -all good but when I try to create the E1 controller I can not do it- Try to set up the ISDN SWITCH TYPE and I get an error also there is no option of isdn in the conf t ? list . Also how do I check the SRST version to confirm the correct S/W is already installed - sh ccm-manager only shows whether it is registered or not . Should not bundled Router come with all the S/W loaded and if so how do you confirm?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.