Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

Busy-Out PRI's on MGCP Gateway

Hi,

One of our customers needs us to busy out there PRI's while they install voice firewalls.  There running CUCM 4.1 and the gateways are all MGCP.  I found the document below and I have a couple questions about the gateway reboot in step 6.  Can I do this reboot ahead of time to get ready and is it safe to leave the settings after they do there install or should I change it back?

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a008076f8d2.shtml

I hope you guys have done or seen this before.

Thanks, Mike

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Busy-Out PRI's on MGCP Gateway

I don't think you need to reboot the physical gateway. You simply need to enable status polling on the MGCP endpoint (in CUCM configuration mode) and do a reset on the gateway from CUCM. No reboot should be necessary.

HTH.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

2 REPLIES

Re: Busy-Out PRI's on MGCP Gateway

I don't think you need to reboot the physical gateway. You simply need to enable status polling on the MGCP endpoint (in CUCM configuration mode) and do a reset on the gateway from CUCM. No reboot should be necessary.

HTH.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Bronze

Re: Busy-Out PRI's on MGCP Gateway

Thanks Bill.

456
Views
5
Helpful
2
Replies