Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Busy signal with incoming calls.

Hi all, I have a problem with the incoming calls. I hear only one tone and the next a busy signal. I don't know if the configuration is correct, the outgoing calls working fine.

The configuration of dial-peer.

voice-port 2/0

translate called 1

supervisory disconnect anytone

cptone ES

timeouts initial 3

timeouts interdigit 3

bearer-cap Speech

!

voice-port 2/1

!

dial-peer cor custom

!

!

!

dial-peer voice 1 pots

preference 1

destination-pattern T

progress_ind setup enable 3

progress_ind alert enable 8

direct-inward-dial

port 2/0

!

dial-peer voice 3 voip

preference 1

destination-pattern 918762551

voice-class codec 1

voice-class h323 1

session target ipv4:192.168.0.14

dtmf-relay h245-alphanumeric

no vad

Many Thanks for all.

108
Views
0
Helpful
0
Replies