01-21-2008 01:46 PM - edited 03-15-2019 08:20 AM
I have a 2801 with a PRI and 2 Fast Ethernet interfaces. We want to dual-home the gateway to separate core switches, with one Fast Ethernet interface to each switch.
My question is what is the best way to do this? I was thinking of putting both interfaces into a BVI interface, but is that ok to use for voice? Or would it be better to use a /30 on each interface, and then use the loopback IP as the routed IP?
Solved! Go to Solution.
01-21-2008 01:57 PM
The BVI works fine with voice. And the routed approach also. If you have a voice vlan to be connected directly to the router, the first solution is probably easier.
Hope this helps, please rate post if it does!
01-21-2008 01:57 PM
The BVI works fine with voice. And the routed approach also. If you have a voice vlan to be connected directly to the router, the first solution is probably easier.
Hope this helps, please rate post if it does!
01-21-2008 02:07 PM
The gateway is only for the Voice VLAN, so we'll likely be using the BVI interface. Thanks for the input!
01-22-2008 03:03 AM
Thanks for the nice rating and good luck!
02-19-2010 10:37 AM
How did this work out for you?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: