Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

call-block can't work in 3745

hi,

i setup a 3745 with CME 4.2. i want to block one number 2508 to call out.but the call block function can't work. the configuration below.

voice translation-rule 7

rule 1 reject /2508/

!

voice translation-profile call-block

translate calling 7

dial-peer voice 779901 pots

trunkgroup CHT

description Voice to PSTN with CHT from international call in Taiwan

call-block translation-profile incoming call-block

call-block disconnect-cause incoming invalid-number

destination-pattern 777

incoming called-number .

prefix 40667799

!

5 REPLIES
VIP Super Bronze

Re: call-block can't work in 3745

Hi,

If this number is within your system, then I believe the direction should be outgoing. From your email, it sounds like you dont want extension 2508 to call out.

SO I suggest to change your config to

call-block translation-profile outgoing call-block.

For things like this, it is rcommended to use COR-list..

HTH

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
Hall of Fame Super Gold

Re: call-block can't work in 3745

Hi,

use call-block with voip DP only. In that case, the translation rule does not need to contain reject, any match is sufficient.

For pots DP, simply use translation-profile and reject.

New Member

Re: call-block can't work in 3745

in my environment, i want to block the ip phone ( call manager express in voice gateway) to call out by dial-peer. But it can't work even the rule is /^.*/.

best regards.

fred.

Re: call-block can't work in 3745

Hi Fred,

Are you trying to prevent one DN from dialing out?

If so, you should apply a corlist to the ephone-dn:

ephone-dn 1

corlist incoming x

Then, on your voip dial peers:

dial-peer voice 1 voip

corlist outgoing y

You would need to add the full corlist configuration, but I think this is what you're looking for. I haven't played with call block on calling number, but there's a good chance it doesn't work on calling number.

hth,

nick

New Member

Re: call-block can't work in 3745

thanks. corlist may be a good solution.

fred.

160
Views
0
Helpful
5
Replies
CreatePlease login to create content