Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Call Block

Hi

I've configured Call Block to any mobile number, by means of the prefix that needs to be dialed to place calls to mobile numbers. Problem is that some users need to be able to call their Supervisor on their mobile number. How can we override the block to allow access to predefined list of mobile numbers ?

5 REPLIES
Cisco Employee

Re: Call Block

create route patterns that match the specific mobiles you need to call

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: Call Block

Hi Jaime, Just creating a route pattern with the mobile of supervisor is enough, or we have to do some other configuratin. pls give the full config info.

Regards

Esa

Community Member

Re: Call Block

Hi, my apologies I shoud've mentioned that is a CME 4.0 installation, so route patterns is probably not available.

Cisco Employee

Re: Call Block

create dial-peers that match the exact mobiles you need to call, same thing just using CME terminology

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: Call Block

Hi, created the dp but this doen not work. The block pattern looks for the 0, and the mobile number starts with 0.

here is my config:

=================

after-hours block pattern 1 0

dial-peer voice 200 pots

description Test block override

destination-pattern 0824476951

port 0/0/0:15

=========================

any ideas ?

316
Views
0
Helpful
5
Replies
CreatePlease to create content