Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Call cannot be completed as dialled for intercluster trunk

Our cluster is 6.0.1.1000-37. Received the message "call cannot be completed as dialled..." when trying to call extension in another cluster. Users in the other cluster (4.3) could call me. The trunk call has been working fine for over a year. Have already restarted pub & sub servers, and recreatd the route pattern and trunk. DNA results are ok. What can i check?

4 REPLIES
Cisco Employee

Re: Call cannot be completed as dialled for intercluster trunk

That error are CSS and partitions misconfigured, check CSS all the way from your local cluster to the remote cluster.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Call cannot be completed as dialled for intercluster trunk

The partition and CSS are correct for the local cluster, the configuration had been working for more than 1 year. The remote cluster is correct as the phones can make call to local cluster succesfully.

Cisco Employee

Re: Call cannot be completed as dialled for intercluster trunk

And have you checked the inbound CSS on the other end???

The fact the remote cluster can call local cluster does not mean it should work the other way or that the config is fine for inbound calls.

It's like having a manager who can call anyone but you cannot dial his number because you don't have the right CSS.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Call cannot be completed as dialled for intercluster trunk

At the remote cluster, after comparing the configuration of another working trunk, the trunk CLIP was set to 'default' instead of 'allowed' and the trunk reset. The trunk call worked after that. Thanks!

323
Views
0
Helpful
4
Replies
CreatePlease to create content