I tried to install the CiscoTSP and test the call contact on outlook. It works fine for all local calls but not work for IDD call. When dialing IDD call such as +44207xxxxxxx, it always show "The call cannot be completed as dialed". However, I have already setup the dialing rules (prefix for access an outside line for long-distnace calls). It seems the dialing rule can not distinguish it is a IDD call.
It seems that you have to set up Outlook correctly first, in order to have it dial IDD correctly. To dial Netherlands, for instance, click the "Phone" or "Fax" button, or whatever, and tell it what country this number is in. It will add +31 for Netherlands, and should display on the bottom how the number will be dialed. Adjust as needed to send the correct digits to CCM.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...