Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Call Disconnect

Dear All

 

We have sip line DiD/DoD from PSTN (Telecom Comp.) ,

Call manger V 7.1 , the PSTN using huawei with codec G7.11 Aluw

 

most of the range working fine , but there are some number wich is analog end point local number, when i call them after they pick up the call , the call immediately disconnects ,

 

In debug , Previous Disconnect Cause=0, Disconnect Cause=1
ccCallDisconnect:
   Cause Value=1, Call Entry(Disconnect Cause=1)

then

Cause Value=16, Tag=0x0, Call Entry(Previous Disconnect Cause=0, Disconnect Cause=16)

then

   Cause Value=16, Tag=0x0, Call Entry(Previous Disconnect Cause=0, Disconnect Cause=0)

then

Cause Value=41, Tag=0x0, Call Entry(Previous Disconnect Cause=0, Disconnect Cause=0)

 

Any one have idea can help me

 

Thanks a lot

 

Best regards

 

then 16 

then 41

 

Any one have idea about it.

 

Thanks

Everyone's tags (2)
1 REPLY

Hello,Please refer this

Hello,

Please refer this document for disconnect cause codes & its description:

http://www.cisco.com/c/en/us/td/docs/ios/voice/monitor/configuration/guide/12_4/vt_12_4_book/vt_ccodes_debug.html#wp1007443

 

it would be good if you could post your gateway configuration with following debugs for a test call.

- debug ccsip message

- debug voice ccapi inout

 

please include calling/called party numbers

 

//Suresh

Please rate all the useful posts

 

//Suresh Please rate all the useful posts.
156
Views
0
Helpful
1
Replies
CreatePlease to create content