Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call Disconnected with after enabled Battery Reversal

Dear All,

We tried to enable Battery-reversal to supervise the answer of remote phone so that CDR on CCM will generate correct duration of each IDD call. However, the call drops after the remote phone pickup the call. On the ip phone screen, it is still showing "Call Proceed". Appreciate if anybody has similar experience and help to find out a solution, thanks!

Setup:

IP phone---ccm4.1----2851(ios 12.4(3b)-----PSTN.

Configs:

voice-port 0/3/3

supervisory disconnect dualtone pre-connect

supervisory answer dualtone sensitivity high

input gain 3

output attenuation -2

cptone HK

timeouts interdigit 2

timeouts call-disconnect 2

timeouts ringing 10

timeouts wait-release 2

connection plar opx 000

!

1 REPLY
Silver

Re: Call Disconnected with after enabled Battery Reversal

Can you rpovide the details of the debug hpi all, debug dsp?

206
Views
0
Helpful
1
Replies
CreatePlease to create content