Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Call disconnection problem over FXO ports in CME

Dear all,

I have a setup of CME 8.5 in which i am using analog lines for incomming & outgoing calls which are connected to 4 FXO ports.issue calls are not disconnecting properly getting this issue peridocally, It seems calls are getting stucked on FXO ports due to this reason line are getting busy. than only solution is is to physically remove the analog line or shut or no shut fxo ports. below is the configuration for your reference.need your help to resolve this issue.

voice class custom-cptone SaudiTelecom

dualtone disconnect

  frequency 425

  cadence 250 250

voice-port 0/1/0

supervisory disconnect dualtone mid-call

voice class custom-cptone SaudiTelecom

battery-reversal

input gain 7

output attenuation -1

echo-cancel coverage 32

cptone BR

timeouts call-disconnect 3

timeouts ringing 5

timeouts wait-release 3

timing hookflash-out 500

timeouts wait-release 3

connection plar 111

impedance complex1

caller-id enable

caller-id alerting line-reversal

caller-id alerting dsp-pre-allocate

5 REPLIES

Call disconnection problem over FXO ports in CME

Hi,

Try to add:

voice class dualtone-detect-params 1

freq-max-deviation 50

voice-port 0/1/0

supervisory dualtone-detect-params 1

HTH,

Alex

*Please rate helpful posts

Hall of Fame Super Gold

Call disconnection problem over FXO ports in CME

If disconnect doesn't work, then the configured tones are wrong.

New Member

Call disconnection problem over FXO ports in CME

Thanks all for your inputs.. i tested all the above inuts but still same issue.

after trouble shooting i noticed that when i am calling from mobile or L.L to compnay number which is hittting gateway & the call is routing to operator if operator is not picking up the phone & enduser is disconnecting the call but operator phone is still ringing no disconnection is happing.

Call disconnection problem over FXO ports in CME

Hi,

You should check the disconnect tones as Paolo suggested.

Best regards,

Alex

Hall of Fame Super Gold

Re: Call disconnection problem over FXO ports in CME

To alleviate this problem you should use connection plar opx.

you should also try cadence 500 500

Also note that most of the other commands you have configured, are useless.

1686
Views
0
Helpful
5
Replies