Call forward all on an analog phone connected to FXS port
Hello, i would like to know if it's possible to use call-forward-all feature on an analog phone connected to a VIC-4FXS/DID (using features access code or something like that). My gateway is MGCP controlled.
Re: Call forward all on an analog phone connected to FXS port
Since you are running MGCP in you gateway, the only way to do configure callforward is from the CallManager. In your CCMAdmin page go to> device>gateway>go to the end points and click on the directory number and go down to the section ?Call forward and pickup settings.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...