I have two users that want their phone calls sent to each other. If some one calls Ext: 8001 and the person is not there they want the call to go to Ext: 8003. If some one calls Ext: 8003 and the person is not there they want the call to go to Ext: 8001. Will this result in a loop, or will the call go to the original person's voice mail like it should?
If someone calls 8001, doesn't pick up and is forwarded to 8003, if 8003 does not pick up they would leave a voicemail for 8003 and not 8001. The same would be if someone calls 8003, doesn't pick up and was forwarded to 8001, where they'd leave a voicemail for 8001's box.
First of all if the DNs are set to forward to each other, it will not go to VM, but in fact create a loop.
Second of all if the call went to VM it will by default recognize the original dialed number, so if the call initially went to 8001 and then was forwarded to 8003 and then VM, it would go to 8001's VM. There is a global parameter than can change this behavior.
Also, CM 7 introduced Call Forward All Loop Breakout and Prevention feature, but I believe it's only for call forward all, and not No Answer.
If Unity Connection you could set up a Personal Call Transfer Rule to transfer the call to the second extension and, if not answered there, transfer the call to the voicemail box of the original caller.
This has the additional advantage that rules can be configured only to operate during working hours so calls outside that time can go straight to voicemail.
I like the Personal Transfer rules mentioned above. Personally, I would probably solve this problem by assigning another line with another extension for each phone. First line of the phone forwards no answer to the second line of the other phone and second line forwards no answer to VM. This way, there is no loop and the call still ends up in the correct mailbox by default.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...