Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Call Forwarding doesn't send original Caller ID info (CUCM 6)

Is there a setting on CUCM 6.1 somewhere that allows the Caller ID of the person being forwarded to show up on the phone of the forwarded call. ie. I set up call forwarding for my desk phone (CUCM 6.1) to go to my mobile phone. The caller ID that comes up on my mobile is our main office number not the number of the phone calling my desk and being forwarded yet when CFA is not enabled, the CID info shows up at my desk (ip) phone just fine.

2 REPLIES

Re: Call Forwarding doesn't send original Caller ID info (CUCM 6

Hello,

On the DN configuration page, if you scroll down to the bottom, there is a section called "Forwarded Call Information Display on Device SEPXXXXXXXXXXXX".

Try checking the box that says "caller number" and reset the phone and see if that works.

Hope that helped.

Re: Call Forwarding doesn't send original Caller ID info (CUCM 6

OK...scratch the above post..I was reading some other posts, and apparently what you are trying to do is spoof a number that is not in the range of numbers that is not on your PRI, and your telco probably doesnt allow this function. See the following post:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Phone%20Services%20for%20End%20Users&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc1e7c2

There are a few other posts similar to it if you search using the string "call forward caller id"

Hope that helped.

2005
Views
5
Helpful
2
Replies