Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Call forwarding isssue

Hi,

I am facing issue with the call forwarding . Calls forwarded to national PSTN or mobile numbers disconnect after 10-15 seconds if unanswered by the destination. Can anybody know if there is any timer configuration in call manager , where we can set to increase the number of rings for the call forwarded number ?

Regards

Mathew

3 REPLIES
New Member

Re: Call forwarding isssue

You can go to "service parameters" and then select "Call Manager" , click on the advanced button.

Find the parameter called "Redirection Ring No Answer Reversion Timer:" and increase the value to a higher value.

You may have to restart the call manager service after tweaking this parameter, you can always test it without restarting the service though.

hope this helps, if it does, please rate!

cheers

New Member

Re: Call forwarding isssue

Hi ,

Can you please confirm what should be the timer value ? Currently it is configuired as

Clusterwide Parameters (Feature - Redirection [3xx])

Redirection Ring No Answer Reversion Timer Required Field                       24 

Maximum Redirection Count Required Field                       70

Which is same for my other working customer.

Regards

Mathew

New Member

Re: Call forwarding isssue

Bump it up to say 36 will approximately allow 3 more rings, and test out.

cheers

269
Views
0
Helpful
3
Replies