1> call forward all - when call forwarding is enabled on the phone by the user, the phone actually does not have a record of the call which are being forwarded. is there other workarounds?
2> call forward if busy - i understand that this option is available on the cucm admin web page. can this setting be accessible elsewhere on the phone or the user web page? or is there other ways to allow the user to configure this option by themselves?
CFwdAll doesn't get applied by itself normally. Maybe someone using a shared line did, or a CTI Application did, but a phone doesn't do it by itself unless a giant spider tapped the softkey :-)
Anyway, talking seriously, you would need to check CallManager SDI traces. There you will see a StationInit(..) message with that softkey CfwdAll message.
So that's the only way to track if an enduser has enabled it or not. Then to find out how it got set, you will need again traces. Definitely both ccm SDI/SDL and perhaps CTI SDI/SDL if it would have come via CTI.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.