We are in the process of upgrading call manager and just upgraded to 4.1(3). I added a 7906 phone to the call manager and it regiesters. The problem is we have 2 call managers and this phone stays registered with the publisher which should be the standby call manager. When i look at the phone and check out the configuration it shows 3 call managers. My primary, secondary and then a 3rd called TFTP. The tftp server is my publisher. How do i make this phone register with my subscriber and then have the publisher as the standby?
this is made by callmanager group, add a callmanager group with subscriber on top (first choice) and publisher under (second choice) and then assign this callmanager group to a device pool, assign this device pool to the desired phone(s)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...