Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Call Manager 4.2(3) Hunt List Configuration Assistance

I have programmed a hunt list, line group and hunt pilot. When I dial the hunt pilot number I get a busy signal. I tried resetting the hunt list. Can anyone offer any assistance? Do I need to restart call manager service?

Thanks,

Dianna

6 REPLIES
Cisco Employee

Re: Call Manager 4.2(3) Hunt List Configuration Assistance

you shouldn't, try resetting all the elements and try again.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Call Manager 4.2(3) Hunt List Configuration Assistance

What elements are you referring to?

Re: Call Manager 4.2(3) Hunt List Configuration Assistance

Another thing to check is the CSS to make sure it's hitting the pilot.

Hall of Fame Super Red

Re: Call Manager 4.2(3) Hunt List Configuration Assistance

Hi Dianna,

I think Java was referring to doing a reset on the Hunt Pilot, Hunt List and Line Group. You can also ensure that on the Hunt Pilot config page that the "Route this Pattern" checkbox has been checked.

Hope this helps!

Rob

New Member

Re: Call Manager 4.2(3) Hunt List Configuration Assistance

Rob,

Thanks for the response.I reset the hunt list and updated the others and continue to get a busy signal when I dial the pilot number. Also route this pattern checkbox was checked. Any other suggestions?

Dianna

Hall of Fame Super Red

Re: Call Manager 4.2(3) Hunt List Configuration Assistance

Hi Dianna,

Hmmmmmm...

Did you check the Partition and Calling Search Space?

Rob

136
Views
0
Helpful
6
Replies
CreatePlease to create content