I am trying to figured out a way to create a custom softkey button that does the exact same thing as iDivert but instead of going to voice mail. I would like it to go to a specific extension. t
We are a call center and we have certain numbers that call us allt he time. I know i can do this with a translation pattern or in our uccx server with the caller id. But i do not want these numbers to go to the extension every time. I only need the option to say divert it to the extension occationally.
Not possible unless you write a third-party application with CTI control over the phone that pops an XML page on the phone during an incoming call. If you press the soft key on the XML page during the incoming call the third-party call control CTI application would need to issue the cal redirect command.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...