The version you specified is not available on CCO. You might have to raise a TAC case to see if the image can be published. I checked the release notes of the latest SU in 8.5.1 and 8.6.2, but this defect is not under the resolved caveats.
Also, reviewed additional info on the buig available internally and looks like this is a cosmetic defect and shouln't affect cucm performance. Is another cluster reboot a viable option ? Because I saw few cases where a server reboot resolved the issue.
With respect to upgrade, you will be upgrading all the servers first and then do a switch version starting from the PUB and the one by one other SUBs in the cluster.
Can you give me a link for a version that I can upgrade to? I can try and perform an upgrade this weekend to see if it clears the errors. It would also be good to be running a supported version. Something in the 8.6 family would be good since I am not quite ready to make the push to 9.0 yet.
I do see that the errors have stopped since early yesterday afternoon, but not until after over 24 hours of these alerts being generated.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...