Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call Manager 8.5, 2800 CUBE, and External Bell Ringer

Hello,

I have deployed VoIP to a noisy environment; gIven the noisy environment, my clients have an external bell/ringer that needs to work at the same time one of the DIDs on a VoIP phone is called. 

I  have the external bell connected to a FXS port off of my 2800 CUBE router with calls traversing the MPLS link. I set things up by creating a dial-peer off the FXS port for the ringer and setup a VoIP phone in CUCM 8.5 with the same DID.  When I call the asssigned DID, the external ringer rings, but the phones does not.  The only way the VoIP phone will ring is if I don't have the bell configured on the FXS port.

I  searched for ideas/answers on the board, and found that some said to  use the stcapp option and to set the maximum call option to 2 or higher  on the number in call manager.  However, this made no difference; I can  either have the bell ring, or the number - but not both.

Anyone have any ideas?

dial-peer voice 502 pots

description External Bell

preference 1

destination-pattern 9195551212*

incoming called-number .

port 0/1/2

!

*NOTE:  Number changed for example.

Thanks!

1 REPLY
Hall of Fame Super Gold

Call Manager 8.5, 2800 CUBE, and External Bell Ringer

Already discussed here:

https://supportforums.cisco.com/message/3700476

Please do not open thread duplicates.

680
Views
0
Helpful
1
Replies
CreatePlease login to create content