Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Call Manager Config Question

I'm fairly new to IP Telephony and Cisco Call Manager. My question has to do with calling Long Distance and Local. How does Call Manager know whether a call is a long distance call or not? Are the local prefixes programmed into Call Manager? If so, where? Thanks!

2 REPLIES
Cisco Employee

Re: Call Manager Config Question

CUCM already has the NANP configured (you can load other depending on your needs), if you use the @ in a route pattern it will match against it and will recognize such calls.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Call Manager Config Question

Hi..

You must have access to the PSTN via a gateway (H323 or MGCP, mainly). For this, you must configure Dial peers in Gateways or AS.

Route Patter must set the Call Manager, so users can make long distance calls.

Gabriel

231
Views
0
Helpful
2
Replies