Call manager express- call forwarding not working correctly
i have and issue with call forwarding. we have an office in Shanghai but dont have an ATA device in the office. but do have a POTS line coming in and its connected to our FAX machine.. we dont want to give out the DN number associated with the POTS line, but, would like to use an existing number we have in our list of available #'s. so i set this number 4701 up to call forward to the other number 608.... within the GUI for CME i set up the Call Forwarding all with 8*608.... for the outbound call. but when i call from my desk the forward happends but ends up with some chinese message about not being able to call a wireless number. the number does work if we call from the outside into the fax machine. any clues. i have attached a log of the sho run config.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...