I have call manager 6.X BE and I'm using route filters for call control. On the local calls route filter I have :
I am also using NANP. My trouble is if a set is placed in local dial only I'm still able to dial 8 didgits (my local is 7) and hit the gateway. The gateway will fail the call after the 9th digit is pressed but call manager should have not let the call make it to the gateway because of the route filter. Any ideas????
I have used DNA and I am hitting the right route pattern because it says Block this Pattern, but instead of hearing the unity voice of this call can not be routed I get a busy signal from the gateway blocking the call because it does not recognize the number.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...