I have a Network with two GW`s one of which doubles as a Gatekeeper. Connected to GWA is a CCM and connected to GW B is a TDM system, if I route via the two GW`s uisng H323 direclty then the call rings and connects OK however if I route via the GK so CCM to GWA to GK to GWB to TMD then the TDM phone rings but does not connect - same if I call from the TDM to IPT. I`ve downloaded the latest IOS so maybe not that any ideas where to start, what debugs etc- many thanks
I check , but why would the same call from the same end devices but not via the GK rather directly usign dial-peers and session target ipv4:x.x.x.x instead of RAS work? The GK set up is basic only used for address resolution for now.
Debug gatek main 10 , I used main 5 is there a doc for the different options?
I`ve got it working , it was the " wait for far h245 capability......" - it as ticked- Unticked it, it worked. If the call went directly GW to GW then it worked but If it went via GW-GK-GW it failed, also if I register one of the CUCM - Our test lab has 2x CUCM , directly to the GK instead of via its GW it also worked even if the radio button was ticked. thanks for your help
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...