Running into an issue with Call Park on new install of CUCM 7.0.2. We have added Call Park codes/Partitions for seperate locations and addded to phone-DN CSS however when testing, calls are placed on Call Park 0. They can be picked up using 0 to reconnect the call.
DN for users/phones 34XXX, 42XXX at this time. All system access codes VM,MWI, Call Park and Meet-me are in the 7XXX range. I have 7700-7704 reg to PUB 7705-7709 re to sub and so on for 3 different buildings at this time.
No, not that I know of. I have 0 out for the three locations operators using translation patterns. They have there own partitions and reside after the call park partitions withing the phone-dn CSS. One of my co-workers is installing CUCM 7.0.2 at the same time and called me because he ran into the issue while setting up in the lab.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...