Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Call Park CME4.2

I configured three park-slots with the same number. IP Phones can park up-to three calls by pressing Park softkey. The problem is when you want to retrieve the parked calls you can retrieve only the first call that was parked. The other parked calls cannot be retrieved and when you dial 333 (park-slot extension) says "unknown number".

Below is my configuration.

ephone-dn 145

number 333 no-reg primary

park-slot timeout 30 limit 10

description park slot for Dealing

no huntstop

!

!

ephone-dn 146

number 333 no-reg primary

park-slot timeout 30 limit 10

description park slot for Dealing

preference 1

no huntstop

!

!

ephone-dn 147

number 333 no-reg primary

park-slot timeout 30 limit 10

description park slot for Dealing

preference 2

3 REPLIES
New Member

Re: Call Park CME4.2

How would you know how to pick up the right call if they are all the same extension?

"I have a call for Bill on ext 333; I have a call for Jana on ext 333; I have a call for Greg on ext 333?"

Can you use 331, 332 and 333?

New Member

Re: Call Park CME4.2

This number is programmed for sales department (3 extensions). All calls for the sales department can be answered and served by any user.

Cisco Employee

Re: Call Park CME4.2

Verify both of these commands in

telephony-service to see if you get different results.

transfer-system full-consult to

transfer-system local-consult.

131
Views
0
Helpful
3
Replies
CreatePlease to create content