I want to setup a range of Call Park numbers to be used by a department's main number. However, I want all phones that call that number internal or external to get a CP number withing that range. We are on CUCM 8.5.1. Can this be done?
I have the range of Call Park numbers created. What I want to happen is if anyone calls ext 12345 and 12345 Parks that call, I want a number from the Call Park numbers I created used. No matter where the calling party number calls from external and internal. Is that be done?
1- Lets select range of numbers which will be used for call park , just you have to select numbers without any overlapping w.
2-Go to CUCM- call routing - direct call part - Add new "type call park number or range" , the select your CUCM IP , you can do redundancy to select other range and select your 2n CUCM IP , and so on .
3-Test , just drop call , from any number to any number , then answer call , the do park , be aware that a call park number will appear on your IP phone screen., then try to get the call from other ext by dial the call park number
If you any additional help , let me and i can share with you screenshots
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.