Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call park disconnects

I have the same problem as mentioned in this Forum at:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&topicID=.ee6c829&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cbecd6c

The problem started only a few days ago.

We are seeing the same problems at mutiple site with mutiple model CME routers.

Cisco IOS Software, 3800 Software (C3845-ADVIPSERVICESK9-M), Version 12.4(20)T1, RELEASE SOFTWARE (fc3)

and

Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.4(15)T5, RELEASE SOFTWARE (fc4)

Partial Config:

===============

ephone-dn 100

number 501

park-slot timeout 60 limit 5 notify 602 recall

label Park 501

!

!

ephone-dn 101

number 502

park-slot timeout 60 limit 5 notify 602 recall

label Park 502

!

!

ephone-dn 102

number 503

park-slot timeout 60 limit 5 notify 602 recall

label Park 503

1 REPLY
Anonymous
N/A

Re: Call park disconnects

Here we are have to enable call park on the CME-users should be able to dial a number 602 and park a call. Here we need to create another ephone-dn called a park slot- when a call is parked it is sent to this newly created ephone-dn until it is retrieved again. Park numbers should be single lines not dual lines

after 10 sec notification by default is given that there is a parked call it get disconnected

give this only

ephone-dn 1

number 602

park-slot timeout 60 limit3

Ensure that a unique call park number is assigned to each Cisco CallManager in the cluster.

The partition that is assigned to the call park number does not match the partition that is assigned to the phone directory number.

182
Views
0
Helpful
1
Replies
CreatePlease login to create content