Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Call Pickup from Hunt Pilot

Hi Everybody

I have the folowing problem:

When a caller dial a office number and select de option 2 from de AA, this option routes the call to a hunt pilot that have 6 extentions associated, if any user try to pick the call the phone display "no calls no pickup" but if the caller form the AA dial any of the 6 extentions an other user try to pick up, the process was complete succesfully

Thank for your help

5 REPLIES
Hall of Fame Super Red

Re: Call Pickup from Hunt Pilot

Hi Juan,

This setup does not work without the "workaround" shown below. Once you apply this you should be good to go

**Set enterprise parameter (System->Enterprise Parameters->Cisco Support Use 1) Cisco Support Use 1 to CSCsb42763 (case sensitive)

This operation added listbox (Route Plan->Route/Hunt->Hunt Pilot->hunt pilot XXXX -> Call Pickup Group) Call Pickup Group.

From this doc;

http://www.ciscotaccc.com/kaidara-advisor/voice/showcase?case=K11612191

1.- Enter

CSCsb42763 (in mixed case) in the Enterprise Parameter 'Cisco Support

Use 1' under the new group 'Cisco Support use Only' and click update. Only the value

CSCsb42763 in this parameter can enable the configuration. Change the

value to anything else to disable this functionality.

2. Go to Hunt Pilot Configuration page and select a call pickup group from the Call

Pickup Group dropdown list and click update.

CSCsb42763

Call Pickup fails on Hunt List

Issue:

Call pickup fails for hunt list when call is CFA from Route Point in 4.1(2)ES41. This is not the designed functionality for this issue and will break the Call Pickup logic.

Workaround:

Use multiple shared lines & CFNA between each shared line.

Related Bugs

Call Pickup fails when ringing line list member

Symptom: Selecting PickUp or GPickUp does not pickup the call from any of the members of a line group. Condition: CM 4.x Workaround: None. Feature not supported. Further Problem Description: Defect CSCsa66224 may appear to have allowed this feature to work in earlier versions.

Call Pickup from line group member fails after es installed

Symptom: A call is CFNA to a hunt pilot/line group. The call can no longer be picked up. Conditions: Calls CFNA to a hunt pilot. 4.1(2)ES36. Workaround: None

Cheers!

Rob

New Member

Re: Call Pickup from Hunt Pilot

Hi


Thanks for your help but i have call manager 7.1, the workaround is the same?

Hall of Fame Super Red

Re: Call Pickup from Hunt Pilot

Hi Juan,

Yes, this work-around applies to CUCM 7.1 versions

as well Give it a try.

Cheers!

Rob

New Member

Re: Call Pickup from Hunt Pilot

Hi Rob

Thanks, i'm going to try and post........

New Member

Re: Call Pickup from Hunt Pilot

Hi Rob

It works perfectly thanks for your help
320
Views
0
Helpful
5
Replies