Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Call Recording and Voice Ports

Dear All,

I am attempting to use VIC3-2E&M interface to divert a call recording out on an analogue interface.

SIP Trunk, Recording Profile etc. works like a charm and I can also 'call' the E&M port directly.

However when the call is initiated as part of a Recording session, the 2951 fails to maintain the call. That is - the LED on the E&M port blinks briefly and then nothing.

The desired end-result is to have the call recording available on the line-level signal on the E&M port.

I am operating the E&M port in immediate signaling mode, Type 2 and 2-wire operation just as I have 'auto cut-through' configured.

Thank you in advance.

Peter Rex Drescher

Everyone's tags (4)
261
Views
0
Helpful
0
Replies
CreatePlease to create content