We are still on CCM 4.3 (soon to upgrade) until then, when dialing a specific number, 916-925-xx4x we get call cannot be completed as dialed. However, I can dial any other number in that string and any other number in that area code. That is a good working number and can be dialed from off our network such as a cell phone or other outside line. When doing a debug ISDN q931 on the gateway the digits dont even make it that far. My first thought was to use DNA to see where the call stops but we can't install the plugin because no one here knows what the private cluster password is. The route pattern is 9.xxxxxxxxxx for long distance calls, route this pattern. It works for every long distance call except for that particular number.
Any suggestions on how to isolate the issue with this number without using DNA?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...