Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Call Routing Dial-Peer

I would like that if all FXO ports in the Router are busy, the call is switchs to another gateway.Is it possible to do this?

Example:

GatewayLocal Configuration:


dial-peer voice 1 pots
destination-pattern 054T
port 0/0/0:15
forward-digits all

preference 0

dial-peer voice 2 pots
destination-pattern 054T
port 0/0/0:15
forward-digits all

preference 1

dial-peer voice 3 voip
destination-pattern 054T
session target ipv4:<ip address of remote gateway>
preference 2

Or instead of specifying the <ip address of remote gateway>, I must specify the ip address of the CUCM. and I assign to the respective CSS to local Gateway.

Regards

2 REPLIES
Hall of Fame Super Gold

Re: Call Routing Dial-Peer

Yes. But to begin with, place FXOs in trunk-group for a clean configuration.

Community Member

Re: Call Routing Dial-Peer

Thanks.

Agreement, the configuration should be as follows:

trunk group  ANALOG
hunt-scheme least-used

voice-port 0/1/1
trunk-group ANALOG

dial-peer voice 10 pots
trunkgroup ANALOG

destination-pattern 054T
forward-digits all

preference 0

dial-peer voice 2 voip

destination-pattern 054T
session target ipv4:
preference 1

Then, Does the CUCM receives the call originated from H.323 Gateway?

344
Views
5
Helpful
2
Replies
CreatePlease to create content