Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

call routing GW CUCM and SIP Trunk

We have CUCM ver 6.1.3.1000-16 and 2801 Gateway. We want to forward one DDI number (external number) from GW to SIP trunk on CUCM. Any idea or example? Thank in advance.

2 REPLIES
Green

Re: call routing GW CUCM and SIP Trunk

yes, lets say my phone number

+1 408 902 2677

when someone calls me PSTN only delivers the last 4 digits 2677 it uses my TI PRI, then instead of creating a DN, i create a Route pattern 2677 and point that to the SIP Trunk, just make sure GW has access to partition where this new RP resides.

New Member

Re: call routing GW CUCM and SIP Trunk

Exactly like that. But I'm confused about last part. If you can give me more detail.

My RP is in partition and in the GW/route list has SIP trunk.

I also expect that my local DN can reach number 2677.

276
Views
0
Helpful
2
Replies