I'm trying to put to work a small voip setup compossed of CCM 5.0 server and a 2821 with a VIC2-2BRI card and IOS 12.4(10). I'm trying to connect to a pbx configuring my VIC2-2BRI card as TE (user side) and using MGCP to manage the gateway.
I have problems to route the calls outside the ip network through the pbx, however I can receive calls (but when I hook off the call drops). I think there's a problem with the call legs, because when I 'debug mgcp' I see somenthing like: NO LEG, ERROR RC=25
In callmanager everything seems to be ok, the gateway and endpoint are registered, and the route pattern report shows the right routing.
I haven't configured any dial peers since I think it's not necessary bur obviously there's something missing. My question is, what should I check next?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...