I'm having a issue when trying to make calls through a gatekeeper from CUCM.
The scenario is the following:
CUCM->ICTrunk->Gatekeper->another CUCMEs and CUCMs
When I try to make a call through the gatekeeper for an unknown number (i dont want to configure arq reject-unknown-prefix), the call setup lasts about 70 seconds and then return fast busy. I want to have fast busy immediately.(if i configure arq reject-unknown-prefix it works, but i need to solve the problem without this command on GK).
Log in CUCM shows this, several times for each failed call:
10/25/2010 18:15:39.460 CCM|DRQ Billing Information - DISCONNECT_REASON=2,TIME=1288026869,DURATION=70,DISCONNECT_STRING=switch congestion,ORIGIN=1,LINE_NUMBER=gtk01_ICTH225,OUTBOUND_GW_IP=<cucm_ip>
10/25/2010 18:15:39.534 CCM|ConnectionManager - wait_AuDisconnectRequest ERROR:NO ENTRY FOUND IN TABLE,CI(44412509,44412510),dcType=1,IFCreated(0,0),PID(0-0,0-0),IFHandling(0,0),MCNode(0,0)
Is there any parameter or workaround for this problem?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.