Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Call Signalling Issue: CIPC keeps ringing!

Hi all,
I've connected my voice gateway to my home phone and to my CUCM.
The voice GW has a PLAR configured on the FXO port so incoming calls are forwarded to the my ip phone on the CUCM.
When I call my home, my ip phone rings and can establish a communication
My problem is with the call signaling:
If I call my home and end my call before someone picks up the IP phone, it keeps ringing!!
Also if in conversation, if I end the call, the CIPC just gives a busy tone but doesn't end the call; I 've to clear it maually.

Could you help to tune this up pls?

Cheers

2 REPLIES

Call Signalling Issue: CIPC keeps ringing!

Set the timeout value under voice port. See if this can help.

voice-port 0/0/1

timeouts interdigit ..

timeouts call-disconnect ..

timeouts ringing ..

timeouts wait-release ..

Rate all the helpful post.

Thanks

Manish

New Member

Call Signalling Issue: CIPC keeps ringing!

Hi Manish,

Thanks for the tips. It can help indeed but my issue was really to terminate a call  by sending call termination message from the GW to CUCM not wait a certain amount of time before ending the call....

231
Views
0
Helpful
2
Replies
CreatePlease to create content