Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call to Voicemail pilot number disconnect from pstn

I have problem connecting to voicemail pilot from pstn, not from internal ip phone. The calls disconnected.

the connection is as below :

pstn -> vgw -> cucm -> cuc

65396789 = voicemail pilot number

96409253 = handphone number

Not sure whether is it due to telco? However the other DID range ( ip phone ) is working fine.

*Mar 6 15:01:24.194 SGP: ISDN Se0/1/0:15 Q931: RX <- SETUP pd = 8 callref = 0x0060

Sending Complete

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98392

Exclusive, Channel 18

Calling Party Number i = 0x4183, '96409253'

Plan:ISDN, Type:Subscriber(local)

Called Party Number i = 0xC1, '65396789'

Plan:ISDN, Type:Subscriber(local)

*Mar 6 15:01:24.202 SGP: ISDN Se0/1/0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0x8060

Channel ID i = 0xA98392

Exclusive, Channel 18

*Mar 6 15:01:24.210 SGP: ISDN Se0/1/0:15 Q931: TX -> ALERTING pd = 8 callref = 0x8060

Progress Ind i = 0x8088 - In-band info or appropriate now available

*Mar 6 15:01:24.274 SGP: ISDN Se0/1/0:15 Q931: TX -> CONNECT pd = 8 callref = 0x8060

*Mar 6 15:01:24.326 SGP: ISDN Se0/1/0:15 Q931: TX -> DISCONNECT pd = 8 callref = 0x8060

Cause i = 0x8590 - Normal call clearing

*Mar 6 15:01:24.370 SGP: ISDN Se0/1/0:15 Q931: RX <- CONNECT_ACK pd = 8 callref = 0x0060

*Mar 6 15:01:24.374 SGP: ISDN Se0/1/0:15 Q931: TX -> STATUS pd = 8 callref = 0x8060

Cause i = 0x82E2 - Message not compatible with call state or not implemented

Call State i = 0x0B

Please advise. thank you very much

3 REPLIES
New Member

Re: Call to Voicemail pilot number disconnect from pstn

Hi Ky,

You can try to add the command "voice rtp send-recv" in your gateway config

jp

New Member

Re: Call to Voicemail pilot number disconnect from pstn

Hi jp,

I have tried but failed. thanks any way.

Re: Call to Voicemail pilot number disconnect from pstn

Hi,

Did you try a translation pattern or CTI RP to reach your pilot number

229
Views
0
Helpful
3
Replies