I have a H323 endpoint registered on a Call manager 4.2. I have seen call transfers aren´t supported with this configuration if only it uses hairpining. Is there any solution else? I've also seen that it could work if h323 endpoint closes logical channel and opens a new logical channel with the same session ID. Has anyone test that?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.