This requires some setup on CM. Here are the steps:
Create a new VM Profile called XferToVM or something like that. Assign a mask of XXXX (where the X's are your extensions, so if you have 4 digit extensions, you need 4 X's.)
Create a CTI route point called XferToVM or something like that. Assign the proper CSS, etc.
For the DN on the CTI route point create something unique such as *XXXX (where X's are your extensions). Assign the proper Partition and CSS, set the Voicemail Profile to the one we created above and then set CFWDALL to voicemail.
To test dial *XXXX (where X's are your extension) and the call should go right to voicemail.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.