This is a pure CUCME environment, not CUCM... also a bunch of small 521SG phones and a UC500.
We put the Callback softkey in a ephone template to be part of everyone idle o seized telephone state. It works on single or huntstop channel lines, but we noticed that there has only ONE ring to the phone which initiates the callback. The customer need more than that, because it's too short to be noticed when several other phones are nearby.
Is it possible to configure callback ring duration?
I haven't found anything... and the customer is annoyed about a brand new system less efective than the old one, which has a perfect callback feature... also when the other line isn't busy anymore, it calls originator first, UNTIL you hold off, then it calls the other party... connect.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...